Previously we introduced our brand new Chemical Guys Ball Buster Drill Attachment.
We showed you the proper techniques and tricks to get your wheels looking just right.
But before you put any of your detailing tools away you want to clean them.
So we'll detach it from our drill, over here I have a bucket set up with warm water and
some Pad Cleaner.
I'll dunk the drill attachment into the bucket letting it absorb the foam and the cleaner
to get into the pores of the applicator.
Just using my hand I'll wring it out to get off as much of the Light Metal Polish that
we were using earlier.
So inside of this bucket I have some warm water and Pad Cleaner which is our active
cleaning agent and the foam is getting into the pores of the applicator and using my hand
I'll help agitate any old polish out.
I'll take it out of the bucket and wring it out on the ground.
Then we'll air dry it by attaching it to the drill and spin it on the highest speed setting
to spin out all the water.
In the same manner where you wring out your pads on the high speed in a Pad Washer, we'll
attach this to the drill and without dunking it in the water but above the water surface
I'll wring it out on the highest speed.
So as you can see it has cleaned up pretty well but to make sure that it is completely
dry I'll take a clean microfiber towel and wipe around the edges to insure that we aren't
putting a damp applicator and this way we don't get any mold and it will be ready for
the next detailing job.
Then we'll take this off!
Không có nhận xét nào:
Đăng nhận xét